What does water switch open mean on my pool heater?
What does water switch open mean on my pool heater?
The heater will only operate for a short time before it cuts off and displays the message “Water Sw Open.” Even if the water flow in the pool intake and return appear normal, it still may be possible the flow could be restricted enough to not allow the pressure switch to close and therefore stop the heater from firing.
What does SW mean on a pool heater?
Since you stated that you’re not getting a good return to the pool, your most likely getting insufficient water flow through the heat exchanger, and this is why you are getting “water sw open” fault code. You will need to check everything in the pool related to water flow.
Why does Raypak pool heater display error : Water SW open?
The heater will only operate for a short time before it cuts off and displays the message “Water Sw Open.” I googled this and most seem to advise an adjustment to the water pressure switch. Do you agree and if so, where is it located and how do I adjust it. If you do not agree, what do you suggest? Show More Show Less
Where is the rollout switch on a Raypak pool heater?
Sounds odd that you turn it on and the switch is open. The rollout switch connects inside the cabinet right behind where the gas pipe comes into the gas valve. I have seen a few cases where the installer moved the rollout switch so they could install the gas pipe and they failed to put it back in place.
Are there cookies on my Raypak pool heater?
Don't knmow\ – Answered by a verified Pool and Spa Expert We use cookies to give you the best possible experience on our website. By continuing to use this site you consent to the use of cookies on your device as described in our cookie policyunless you have disabled them.
What causes a Raypak heater to roll out?
The rollout switch is activated when something like wind causes the flames to shoot out towards the front of the unit. This is usually caused by high winds while the unit is running. Are you sure it it said rollout?
The heater will only operate for a short time before it cuts off and displays the message “Water Sw Open.” I googled this and most seem to advise an adjustment to the water pressure switch. Do you agree and if so, where is it located and how do I adjust it. If you do not agree, what do you suggest? Show More Show Less
Is the rollout switch on my Raypak 156 open?
I have a Raypak 156 heater on my spa powered by propane. I replaced the rollout switch, but it opened again after a few uses, suggesting the switch was doing its job properly. Makeup air seemed unobstructed, and the exhaust flue was clean, so I decided to bite the bullet and dig into the heater guts. Following the Raypak YouTube instructions
Where can I buy a Raypak pool heater?
Amazon.com: Forney 70487 Tube Brush, Nylon with Wire Loop Handle, 15-1/2-Inch-by-1-1/4-Inch: Home Improvement Shop KKBESTPACK at the Amazon Arts, Crafts & Sewing store. Free Shipping on eligible items.
Do you need to replace the roll out sensor on a Raypak pool?
If you have spiders in the equipment area, its probably the latter. Switch is a one time use and needs to be replaced AND THE PROBLEM FIXED! Dont just replace the roll out sensor and expect it to work for long. Dont pay more than about 15 dollars for it either.
